What is the operation process of SAMSUNG Pick & Place Machine?

The work process of SAMSUNG Pick & Place Machine needs to be carried out in accordance with the specifications. Next, let's talk about the specific operation process of SAMSUNG Pick & Place Machineand what are the specifications.

This is the content list:

l  What is the preparation process of SAMSUNG Pick & Place Machine?

l  How to choose the placement program of SAMSUNG Pick & Place Machine?

l  What are the requirements for quality supervision of SAMSUNG Pick & Place Machine?

What is the preparation process of SAMSUNG Pick & Place Machine?

The technician takes the top PIN board of the SAMSUNG Pick & Place Machine that has been made, and puts it into the corresponding position in the machine, and waits for the PCB board to be fully positioned

Then put the top PIN into the top PIN position marked by the white paint pen, and check whether there is a gap between the top PIN and the PCB board, and then start production after the check is OK.

Check the air pressure of the SAMSUNG Pick & Place Machine: check if the air supply is normal before mounting. If the air pressure is abnormal, it must be solved in time and it cannot be turned on.

Power on: Rotate the MAIN SWITCH switch to turn on the main power of the machine, and the standby unit starts normally.

Start the SAMSUNG Pick & Place Machine program: open the MARK5 program on the desktop and enter the SAMSUNG Pick & Place Machine working interface.

l  Warm-up: Select "Warm-up" in the "Application" of the main menu. Generally, the warm-up time of SAMSUNG Pick & Place Machine is 10 minutes. After the warm-up is completed, the SAMSUNG Pick & Place Machine can be patched.

How to choose the placement program of SAMSUNG Pick & Place Machine?

Select the open file option under "file", find the file corresponding to the PCB board and open it.

Go to "pcb edit" mode, select "step", move the flying camera to a random patch component

Observe whether there is any deviation between the component coordinates and the component coordinates on the program. If there is any deviation, adjust the SAMSUNG Pick & Place Machine program. If there is no deviation, you can enter the "production" mode.

After entering the SAMSUNG Pick & Place Machine production mode, click "Finish"-"pcb download", click "Start" when finished, and then press the green start button on the fuselage, the machine will automatically perform normal placement.

What are the requirements for quality supervision of SAMSUNG Pick & Place Machine?

The first piece posted by SAMSUNG Pick & Place Machine must be checked by quality control inspections. After confirming that the board has no defects such as missing parts, missing parts, wrong parts, and offset, it can be mass-produced. It is necessary to adjust the machine in time if there is an error in the first piece, and correct the wrong piece manually. Then adjust the component position of the smt placement machine to the best state for reproduction.

When an alarm occurs during the SAMSUNG Pick & Place Machine placement process, the operator must check the fault in time and solve it in time. When changing the SAMSUNG Pick & Place Machine, be careful not to load the wrong material.

After SAMSUNG Pick & Place Machine placement is complete, exit the program and turn off the placement machine. The feeder that needs to be dismantled is placed on the dedicated feeder rack.

Finally, do a good job of cleaning theSAMSUNG Pick & Place Machine. When producing a φ5 single and double color 64×32 PCB board, because the board is relatively large, it is necessary to install a thimble at the bottom of the PCB board to prevent the PCB board from sinking due to gravity.